30W Network Column Mount Loudspeaker
Integrated with Network audio decoding, amplifier and speaker
High speed ARM+DSP Processor
Hi-Fi linear array speakers and Class-D stereo power amplifiers
In Built loop detector to monitor remotely the health status
Wide range of network Protocol such as TCP,UDP,IGMP,ICMP,ARP
Multiple options of Audio codec like ADPCM,MP3, MP2, PCM
Wall Mount Installation Design with Mounting Bracket
| Model no | OD-NCS30A |
| Specifications | |
| Rated Power | RMS 30W |
| Line Input | DC 30V, 1x RJ-45 |
| Network Port | RJ-45(10/100Mbps) |
| Network Protocol | TCP,UDP,IGMP,ICMP,ARP |
| Audio Compression | ADPCM,MP3, MP2, PCM |
| Audio Bitrate & Sampling | 8kHz-45kHz, 16bit, 8K-320Kbps |
| Frequency Response | 100-18KHz（±3dB) |
| S/N Ratio | >90dB 190Hz-18KHz |
| Installation | Column/Wall Mount |
| Enclosure | Alluminum in White Finish |
| Dimennsion | 82(D) x 86(W) x 500(H) mm |
| Weight | <2.5Kg |
240W Network audio mixer Class D amplifier
Designed IP PA Amplifier for the small size multiple room application such as warehouse, hospital, school and office
Built-in Audio Controller and 240W Class D(constant voltage of 100V) amplification
Multiple music programs could be matrix distributed from server to different zones
Built-up over existing LAN/WAN network system, non-dedicated network system is needed
Power up time is <1sec, built In colorful 2 Line LCD Display
Support LAN/WAN, Ethernet system, support over gateway and router
Wide range of network Protocol such as TCP,UDP,IGMP,ICMP,ARP
3 mic inputs, 2 aux inputs and 1 line output, With 100V speaker outputs by screw terminal
Separate volume and tone control for each 5 inputs
VOX Priority override Input at Front panel MIC 1
Output priority level can be define from 5 sources, editable network program
Third party system integration by 0V alarm output port
less emission of the heat and higher efficiency
Automatic Standby power-saving mode when no signal input
19” Ready rack mount Installation design
120W Network audio mixer Class D amplifier
Designed IP PA Amplifier for the small size multiple room application such as warehouse, hospital, school and office
Built-in Audio Controller and 120W Class D(constant voltage of 100V) amplification
Multiple music programs could be matrix distributed from server to different zones
Built-up over existing LAN/WAN network system, non-dedicated network system is needed
Power up time is <1sec, built In colorful 2 Line LCD Display
Support LAN/WAN, Ethernet system, support over gateway and router
Wide range of network Protocol such as TCP,UDP,IGMP,ICMP,ARP
3 mic inputs, 2 aux inputs and 1 line output, With 100V speaker outputs by screw terminal
Separate volume and tone control for each 5 inputs
VOX Priority override Input at Front panel MIC 1
Output priority level can be define from 5 sources, editable network program
Third party system integration by 0V alarm output port
less emission of the heat and higher efficiency
Automatic Standby power-saving mode when no signal input
19” Ready rack mount Installation design
20W Network wall class D amplifier
Built-in Audio Controller with 20Wclass-D amplification with power out 8 Ohms
Installed Microphone on the terminal to enable the monitor on-site activities from main control room
Support LAN/WAN Ethernet system, support over gateway and router
Priority Announcement programming network program, local mic input and local line input
1 Analog Audio output to connect External amplifier
Wide range of network Protocol such as TCP,UDP,IGMP,ICMP,ARP
Multiple options of Audio codec like ADPCM,MP3, MP2, PCM
Built In colorful 3 Line LCD Display, Infrared remote controller
Power up time is <1sec
less emission of the heat and higher efficiency
Wall Mount installation design
Allow to connect with PBX telephone switchboard and the public telephone network via the analog phone line
1 FXO interface (standard) with options of the 4/8/16 FXO interfaces (for two or more calls)
Make a random full-duplex intercom to any IP terminals through the outside line
Available for the external line input to broadcast to the IP terminals
Auto off announcement after Phone hang off
Telephone Calling over LAN/WAN and Ethernet network
PoE Based IP 6W Ceiling mount speaker
Compatible with both IEEE 802.3af & IEEE 802.3at
Support with existing POE switch network system
Multiple POE speakers enable to be several group or zone defined
Remotely adjust the volume of the output on the server
Different music or pre-recorded voice message simultaneously broadcasted through different POE speakers
Redundant design PoE & DC12V power supply
Network Paging Station remote paging solution for Network PA System
All Zone, Group Zone, Individual zone and selected zones paging options
Max support 300 call stations working at simultaneous
Built-in LCD display, power and zone selection
Built-in microphone, monitor speaker for two way intercom use
Eight zone selector, microphone on and number buttons
Nine levels of priority setting in the software
Power up time is <2sec
Aux Input and Output for External devices
40W Network Column Mount Loudspeaker
Integrated with Network audio decoding, amplifier and speaker
High speed ARM+DSP Processor
Hi-Fi linear array speakers and Class-D stereo power amplifiers
In Built loop detector to monitor remotely the health status
Wide range of network Protocol such as TCP,UDP,IGMP,ICMP,ARP
Multiple options of Audio codec like ADPCM,MP3, MP2, PCM
Wall Mount Installation Design with Mounting Bracket
60W Network audio mixer Class D amplifier
Designed IP PA Amplifier for the small size multiple room application such as warehouse, hospital, school and office
Built-in Audio Controller and 60W Class D(constant voltage of 100V) amplification
Multiple music programs could be matrix distributed from server to different zones
Built-up over existing LAN/WAN network system, non-dedicated network system is needed
Power up time is <1sec, built In colorful 2 Line LCD Display
Support LAN/WAN, Ethernet system, support over gateway and router
Wide range of network Protocol such as TCP,UDP,IGMP,ICMP,ARP
3 mic inputs, 2 aux inputs and 1 line output, With 100V speaker outputs by screw terminal
Separate volume and tone control for each 5 inputs
VOX Priority override Input at Front panel MIC 1
Output priority level can be define from 5 sources, editable network program
Third party system integration by 0V alarm output port
less emission of the heat and higher efficiency
Automatic Standby power-saving mode when no signal input
19” Ready rack mount Installation design
